The injection and plasticizing drive combines the linear movement via gear racks with the rotary movement for dosing in one compact unit.
Injection unit for all-electric injection molding machines in combination with an FZ plasticizing gearbox
Compact and efficient – the combination of the linear movement with the rotary movement for the worm drive results in shorter cycle times and therefore greater cost-effectiveness. The high precision and repeat accuracy minimize part errors and optimize margins.
Synchronous servomotors with a countershaft gearbox (from ZS 452-I) have low mass moments of inertia and ensure extremely dynamic and low-noise operation.
The back-pressure bearing and a load cell, which supplies measurement and control signals by means of an amplifier, are integrated in the piston for the injection.
IEC flange & coupling
for IEC standard motors
Adapter flange and coupling for all common
IEC standard motors and compact high-performance motors.
Overload clutch
Cooling
The choice of the appropriate cooling method depends on the specific requirements of the gearbox, the operating conditions and the environmental factors. A thorough analysis of the thermal load and operating parameters is essential to determine the best cooling strategy.
The following are available:
Cooling coil
Directly mounted pump with plate heat exchanger
Cooling unit with electric pump
Monitoring equipment
Monitoring devices for gearboxes are crucial to ensure the reliability and efficiency of machines. These devices monitor various parameters such as oil level, temperature, vibration and torque to provide early warning of potential problems.
If a standard gearbox is not an option for your application, give us a call. Our specialists will be happy to advise you and work with you to find the right solution for every technical challenge.
T +49 (0) 711 – 448 14-0
vertrieb(at)knoedler-getriebe.de
Your inquiry: Phone: +49 (0) 711 – 448 14-0 | eMail: info(at)knoedler-getriebe.de
