Many operations in steel production require drives with two or more output shafts. This applies not only to rolling mills, but also to many other processing stations within sheet metal processing. Stretching, straightening and dividing are only a small part of the steps that strong transfer cases require.
Torques can be designed according to customer requirements
The designs of the transfer gearboxes vary according to requirements as helical flat gearboxes or helical bevel gearboxes.
Motor connection via free drive shaft or IEC connection.
Sizes, outputs, number of output shafts, centre distances and torques are designed according to customer requirements.
IEC flange & coupling
for IEC standard motors
Adapter flange and coupling for all common
IEC standard motors and compact high-performance motors.
Overload clutch
Cooling
The choice of the appropriate cooling method depends on the specific requirements of the gearbox, the operating conditions and the environmental factors. A thorough analysis of the thermal load and operating parameters is essential to determine the best cooling strategy.
The following are available:
Cooling coil
Directly mounted pump with plate heat exchanger
Cooling unit with electric pump
Monitoring equipment
Monitoring devices for gearboxes are crucial to ensure the reliability and efficiency of machines. These devices monitor various parameters such as oil level, temperature, vibration and torque to provide early warning of potential problems.
If a standard gearbox is not an option for your application, give us a call. Our specialists will be happy to advise you and work with you to find the right solution for every technical challenge.
T +49 (0) 711 – 448 14-0
vertrieb(at)knoedler-getriebe.de
Your inquiry: Phone: +49 (0) 711 – 448 14-0 | eMail: info(at)knoedler-getriebe.de
